This behaviour is not new, I had it from the very beginning.

3D Printing
, , ,
1

This behaviour is not new, I had it from the very beginning. But this time, it’s too much. :frowning:
For me it locks like the material feed around the edges is to high. Is there a parameter at my Sanguinololu 1.3a which can be lowered?

Update: @ThantiK Thank you for your advice. That did the trick. :slight_smile:

https://plus.google.com/photos/105128350515777764895/albums/6077425640097761985?authkey=CNvL6Kvz2_nnnQE

0869a80c62b8bcbb0d35af7da0858a0b.jpeg
0869a80c62b8bcbb0d35af7da0858a0b.jpeg3264×2448 1.26 MB

0034598c64bd433286f4aea0cb306b99.jpeg
0034598c64bd433286f4aea0cb306b99.jpeg3264×2448 1.02 MB

2

You’re talking about the blobs around the corners? Increase your XY jerk a bit. Looks like you may have it set for 0.

3

@ThantiK OK, I’ll try that :slight_smile:

4

I get that when I’m printing really fast or when I’m over extruding. Which firmware are you using and maybe post the Configuration.h file to postbin or something and link it.