Hi, Anyone using Marlin Power loss recovery with the latest Marlin?

3D Printing
, , ,
1

Hi, Anyone using Marlin Power loss recovery with the latest Marlin?

I tried to do as per this video.

Print is resuming after the power loss, but Z axis is not moving up. It is printing in the same layer where the print was stopped. Z is not going up.

Any solutions please.

2

Following as I’m curious about the cause and solution. Are the X-Y patterns changing as it prints or is it just printing the same layer over and over?

3

@Jeff_Parish Unable to judge it. I have tried with cal cube only, so cant say whether it the same layer over and over.

But in the screen, it is showing as "Home Z first’ and the value of Z axis remains same without changing.

4

What style printer do you have? Would it be possible to home it or does the nozzle need to touch your bed?

5

Open an issue on Marlins GitHub page.