Guys, is anyone using marlin autobed leveling with a mechanical endstop?, i have to tune zoffset for each print, once tuned, it will work for that print, but not for the next one, usually, the nozzle gets too close to the bed when doing g28.
Mechanical endstops here on every single one of the DeltaMakers I work on, without problem.
everybody uses mechanical endstops for the z probe, so im puzzled on what im doing wrong. Maybe i should home slower?
Do you have a bed with springs on the corners? Sometimes those will cause this issue.
no springs
Is there a how to guide for implementing auto level on a Mendel90/melzi/marlin setup ?