I’m getting a Geeetech A10 like @HalfNormal recently acquired.
I will definitely have dry boxes to store my filament, humidity is bad here on the NC coast. Been hanging around you 3D printing peeps long enough to have picked up on a few things. 
I also know enough to know that my big learning curve is going to be learning how to dial in the settings for my printer.
The decision to finally getting a 3D printer was made easy because I knew that I would have support of all the great makers here in this community. People that will be happy to answer all my newbie questions without being condescending, like you see sometimes see in other groups (coughfacebookcough) . 
We don’t get a lot newbie questions here (at least that I notice), so I plan to ask lots of questions to hopefully draw other people in with conversations. I created this Discussion sub cat because there didn’t seem to be a obvious natural place to have these discussion other the under the general parent cat, which I don’t like. I’m open to change this if anyone thinks there is something better.