I have finally finished the design of a box for my Neje

Community Made by Makers
1

I have started building this design, I have named it Elena’s Box.

3 Likes
2

Hello,I have made some small improvements to my Elena’s Box, handles to lift the honeycomb table, red corners of the drawer so that they are easily visible, logo on the inside, change of color of the smoke extraction collector, although I have some doubts about whether to install linear actuators or not, the ones that would work well are quite expensive and perhaps with a simple counterweight I will also achieve agility to open and close the lid. What do you think?

3 Likes
3

Why not a gas spring with an over-center mechanism? Lift it slightly and it pops open, push it down and near the bottom it loses mechanical advantage and closes all the way.