Geetech A10 skipping steps

[NedMan (Ned Hill)]

@Paulo_Nobrega

So, i have no idea of those are what they should be. Also, if I bought correct tmc2208, don’t really know what voltage I should set on them.

I seem to remember setting my tmc2209s to 0.9V. 1.0V should be fine. Here is a discussion I did about installing my tmc2209s

TMC2209 Driver Upgrades to a Geeetech A10

Upgrading my new Geeetech A10 printer to use TMC2209 drivers in place of the A4988 drivers to make the printer quieter. I could have used TMC2208s but @mcdanlj convinced it was worth the couple extra $ per driver to get the TMC2209s because: I got these BTT ones. Because the trinamic chips like the 2208s and 2209s have the motor direction reversed, compared to the A4988s, you have to either swap the motor wires on the board connecters or change the motor direction in the firmware. I’m fl…

I let the firmware handle the DIR change so I didn’t need to use any jumpers. As @mcdanlj said the firmware I was using was integrated into core Marlin. Here is a video installing Marlin on the A10.

Update Marlin Firmware in Minutes Geeetech A10M & MORE! Simple Steps