Work is busy, but managed to squeeze off a print today.

3D Printing HercuLien and Eustathios
, ,
1

Work is busy, but managed to squeeze off a print today. Some ringing at the corners, and you can probably see where I went to 200% but then brought it back down to 150% after a few layers. I need a better camera than the potatoe that they built into my phone.

Assembling the repo has stalled in favor of designing and building an enclosure for the machine that my institutions’ health and safety committee is requiring.

:confused:

My engineering club students and I are working on the enclosure now. Needless to say this is a kink I did not expect. And don’t get me started on UFP’s…

c7a80c509cfc2f1cb91d5167c63cfdbe.jpeg
c7a80c509cfc2f1cb91d5167c63cfdbe.jpeg1440×2560 303 KB

978eacdfc4ee05a96ce97e15b01432d1.jpeg
978eacdfc4ee05a96ce97e15b01432d1.jpeg1440×2560 179 KB

2

Well will definitely not start on UFP’s as I don’t know what it means. But great looking print overall and yes I can see where you speeded it up . But I am interested in what your initial speed was and what filament?

3

Ultra Fine Particles. :frowning: they’re emitted during the printing process.

Started at 60, went to 90, then 120, then back to 90 for the remainder.

4

Great job @Matt_Miller !