Wanted to try and use most of the Z-height on my Tria and do

3D Printing
, ,
1

Wanted to try and use most of the Z-height on my Tria and do it relatively fast. Single perimeter spiral print in Colorfabb PLA/PHA. 40mm/s, 215C, and 80% cooling for the entire print at 0.2mm layer height. In total it took about 4.5 hours and is 430mm tall. Surface finish is impeccable everywhere.

Next, to try a more complicated, large print… I’m open to suggestions!

f487a69b503382b6875d8acbfee32739.jpeg
f487a69b503382b6875d8acbfee32739.jpeg1536×2048 422 KB

2a057e10d3555b49396460b636eb49eb.jpeg
2a057e10d3555b49396460b636eb49eb.jpeg1536×2048 332 KB

ebdc2f55f1db682f9ebae9c32a603660.jpeg
ebdc2f55f1db682f9ebae9c32a603660.jpeg1536×2048 479 KB

2

You always make me jealous with your prints. I say get yourself 3D scanned in an awesome action hero pose… and print yourself :slight_smile:

3

A tall 430mm print on a skirt! Brilliant!