This was a bit of an improvement over the last one,

diycnc-discuss
gplus
(George Allen) #1

This was a bit of an improvement over the last one, but I’m still trying to learn the toolpath options in Fusion 360.

(Don Kleinschnitz Jr.) #2

Yes been there doing that … and there are alot of options :(!

(Frayre Jesus) #3

Fusion is a great software, good luck whit your proyect

(James Rivera) #4

There are a lot of options in the FreeCAD Path workbench, too, which is what I’m currently dealing with. I think I’m starting to get a handle on it. Good luck with Fusion360–it’s a powerhouse.