Soldered up my level shifter and pin 2.4 with headers on my 4xc to

Controllers Smoothie
,
1

Soldered up my level shifter and pin 2.4 with headers on my 4xc to convert my k40 laser over is their any other headers I should solder up to ease my conversion from the crappy m2nano board to the awesome smoothie? Really want to do this the right way and not fry a board #Smoothiefy

2

+Peter van der Walt can’t wait your K40 arrived, and got your view on point 5. I have a feeling for the need of a resistor to adapt the signal into PSU PWM or to find out why it’s not optimum without.

3

@Alex_Krause pin 2.5 or 2.6, and agree 4XC should come with connectors soldered, if you have big fingers and poor sight, that make that point tricky (@Arthur_Wolf )

4

Does this make sense https://goo.gl/fgDHJj

5

+Peter van der Walt​ step four led and resistor are in series of each other but parallel to the pwm output?

6

+Peter van der Walt No soft-endstops yet, but seriously working on it ( just wrote a spec for the feature to weed things out )