So I'm trying to get better at using KISSlicer and came across this video.

3D Printing
,
1

So I’m trying to get better at using KISSlicer and came across this video.
My Q is for those that know K.slicer, is this a good starting video guide to KISSlicer?
I’m going to start messing around with it using some info from this tomorrow. The points I’m going to mess with are ‘Flow Rate’, temp, inset surface., then on to the destring settings.
http://www.youtube.com/watch?v=zVpzIj3G6ow

2

Well so far I’ve changed ‘Extrusion Width’ from .48 to .5 . That helped out a little. Then I changed the ‘Flow Tweak’ from .68 to 1 and it’s looking LOTS better.
The above video did wonders for my print quality. Tnx YouTube’er ‘Transcendtient’ .