Not too bad for a first-print in LAYWOO-D3 using my default PLA settings.
Nozzle @ 210C, HBP with blue painters’ tape @ 40C, sliced with 3 shells and no fill.
Retraction needs some tweaking, but it should clean up pretty well.
http://www.flickr.com/photos/81685076@N00/8274300752
Wood filament… I want it!
So do you cleanup with sandpaper!?
Not this specific print, but I do want to try various wood-finishing tricks & materials to see what translates.
Where did you get the wood filament from? Looks very cool!
A test roll (aka not for sale yet) of 1.75mm filament from Voxel Factory.
Ah, so that’s why I couldn’t locate it on their website.