Might as well start this project as well.
OpenRC 1:10 4WD Touring Concept RC Car
Does this look like the correct drive belt?
What drive shafts are you using from Conrad? Is there somewhere besides thingiverse that will have more information on the Touring Concept RC Car? Like which motor etc.
http://www.amain.com/rc-cars/xray-high-performance-kevlar-drive-belt-front-3x507mm-xra305431/p12090
The driveshafts are from Conrad: http://www.conrad.com/ce/en/product/231117/Reely-Spare-part-CVD-Cardan-shaft-74-mm-VX35701?queryFromSuggest=true
The belts are from Amain:
1 x XRAY High-Performance Kevlar Drive Belt (Front - 3x507mm) (XRA305431) = $19.49
1 x XRAY 3x183mm High-Performance Kevlar Rear Drive Belt (XRA305444) = $17.99
Not another Conrad part… 
Printed the rims. Might try printing the tires tomorrow with Ninjaflex for the first time. Not sure if I will print any other parts after that since I can’t order from Conrad.
@bcrazycramer yea, sorry about that but the touring car was designed even before the Truggy. But there will be no more Conrad parts in the future, I promise!
@Daniel_Noree I am so excited to see this next model of the OpenRC. I think for my 40th birthday, I will print an OpenRC Car or two or three. 
@Daniel_Noree …And thank you for no more Conrad parts. It’s too bad they don’t ship to the United States because they sell a lot of cool stuff.
@bcrazycramer i was wondering. where did you end up getting the driveshafts since Conrad doesnt ship to US?