@Leon_Yuhanov what do you mean by “falling apart” . Signal decaying, or voltage not being able to make it across the matrix due to amps and losses on the too small traces?
If the latter, most matrices have power re-injection points in the middle to help with this.
@Michael_Sime Here you, this is the 1st rev prototype print out of the 2020 strip thats 5mm wide next to a 5050 144ppm strip on 12mm
missing/deleted image from Google+
Not quite 2 pixels per cm, but very close, well done. Can’t wait until I can buy a matrix from you
@Marc_MERLIN @Michael_Sime The last prototype pcb layout i made had these on 4mm strip with a 4.6mm spacing per pixel. Which is about 2px per cm. But until I actually fab it up its all just theory
missing/deleted image from Google+
found these, 22 x 22 in same size where normally one finds 16 x 16. not quite as dense as what you are after but could help those in need.
@Mark_Estes that is a nice find, thank you. Hopefully we’ll eventually find sellers just offering 32x32