I'm still curious about the popularity of that Buildabotics controller.

diycnc-discuss
gplus
(George Allen) #1

I’m still curious about the popularity of that Buildabotics controller. I keep listening out for word about the success of their company. I’m satisfied with the choice of motion controller I chose, but their set up all confined to a nice controller box looks quite handy. I think I would have chosen their set up if I didn’t intend on eventually adding at least one, if not two additional axes.

(Jarrid Kerns) #2

Seems a bit expensive, but if you consider 4 high power stepper drivers, a control board, raspberry pi, LCD, power distribution and housing, 450 isn’t too bad! Thanks for the insight