I was going to give printing the SketchUp logo a go over the weekend.

3D Printing
,
1

I was going to give printing the @SketchUp logo a go over the weekend. I am not sure I have the right colour of red filament so I thought I’d ask for suggestions from you fine folks about what colour I should try.

http://blog.sketchup.com/article/get-started-3d-printing-make-sketchup-logo

2

Looks like orange might take it. I’ll check again at noon (UTC + 0) then try to print this evening.

3

Orange has won. Guess I best get printing when I head home this evening.

4

I have printed out the logo and added it to the Show-n-Tell channel. I thought the colour was going to be much more orange than it turned out to be in the photos, I hope you do not mind. There is also a set of images linked as a make on Thingiverse for the model http://www.thingiverse.com/make:301424