I made this video to answer some questions I've collected in the comments below

3D Printing
,
1

I made this video to answer some questions I’ve collected in the comments below the videos. It is in Italian with En sub, I hope you like :slight_smile:

2

complete bull, as usual.

3

@Rien_Stouten That’s pretty harsh, why do you think so?

4

Because that small difference in diameter would not cause that much problems. But he does two different things here, filing down a heatbreak, and oiling the heatbreak. And then follows up with the conclusion the filing down was necesarry. Typical of this spammer and his conclusions.

5

Buy an original v6 and all your problems and theories will end. There are more problems in these fucking clones.