I have everything on my cartisian wired up and now its time to calibrate.

3D Printing
,
1

I have everything on my cartisian wired up and now its time to calibrate. One question about that though. I had homing working on Kamikaze 1.0, but I noticed there was 1.1.0 so I upgraded to that and now I can’t get my printer to home the right direction with the same local.cfg. I want X to home negative, and Y to home positive(endstop at front of bed) yet it does the exact opposite for homing. For regular moves the axis go the commanded direction. I have tried flipping the signs and X still goes positive and Y still goes negative regardless of whats there. Am I missing something elsewhere in the configs?

My geometry section looks like this.

[Geometry]
offset_x = -0.19
offset_y = 0.19
travel_y = 0.25
travel_x = -0.25
offset_z = 0.0001

2

I realize I had the signs wrong on the offsets but now it is homing right. The new issue is I get alarm stepper fault while heating the bed, no steppers are on but it trips all four for some reason.

3

So with the new PSU I am not having any issues. There must have been something in there causing current spikes.