Hi guys posted this on the chilipeppr group too but wanted to add it here to see if anyone has successfully operated Gcode from JTech photonics laser etch program On TinyG and chilipeppr?
I can get it to start but it pauses right when the laser should come on and just stays there not moving.
Any help or tips is very much appreciated!
Peter I was looking at the L-cheapo laser before the JTech, L-cheapo is well cheaper for sure. But I do like the laser drivers and safety features that JTech provides. The software is very affordable but if they won’t cater to TinyG I may just have to look elsewhere. Laserweb seems like a solid option. Do you have any other lasers you would recommend?
Good point!