Hello,
At the beginning of the year I built myself a laser cutter, which runs with grbl1.1 over an Arduino UNO.
As a software I would like to use Laserweb4. The basic settings like homing, laser test & jogmode already work :-).
Now I wanted to start the first job but always the error comes:
! 22 - Feed rate has not yet been set or is undefined!
Does anyone have an idea what it is or where I still have to set the feed rate.
($ 30 = 1000, $ 31 = 0 are already set accordingly)
Attached are a few pictures of the settings in the LaserWeb4
cheers Steffen
