Harder, Better, Faster, Stronger: The E3D Volcano is the longest,

Thomas_Sanladerer · February 22, 2015, 9:45pm

Harder, Better, Faster, Stronger: The E3D Volcano is the longest, thickest and fastest hotend option out there!
http://www.youtube.com/watch?v=1x_V-OhnO5U

ThantiK · February 22, 2015, 9:48pm

Interested in that BBB/cape review!

Thomas_Sanladerer · February 22, 2015, 10:08pm

@ThantiK I’ve been pushing that one back for way too long already (partly due to reasons I couldn’t control). But it’s next in line, no matter what!

tylor_abel · February 22, 2015, 10:45pm

@Thomas_Sanladerer got my bbb/bebopr++ pushing my volcano!

Nathan_Buxton · February 22, 2015, 11:23pm

Harder, better, faster, a little less stronger (heat break).

Mark_Fuller · February 22, 2015, 11:35pm

Considering this for infill speed improvement.

Matthew_Satterlee · February 23, 2015, 3:52am

Just the motivation I need! … I’ve had my Volcano for a few weeks now but haven’t had time to get it going.

Gus_Montoya · February 24, 2015, 4:59am

Saw the review, and am waiting for my own now. My intention is to print car parts, but I have not yet found a group of suitable filaments that can withstand 200-250 degree temps. I imagine that will be more then enough so that it can tolerate engine heat etc. I want to make a EFI intake plenum for my car. I see no reason why I need to spend $1K plus on such an item. Would you @Thomas_Sanladerer happen to have some suggestions?

Mark_Fuller · February 25, 2015, 5:56pm

PEEK filament is what you’re looking for. Alternatively, you could do a porous infill and fill the voids with epoxy. Or you could print with what you have and wrap it with fiber reinforced epoxy.