I have a cronosmaker cnc , Never used or set up before.
something like this but by cronosmaker
apparently they went out of business back in 2021.
i have no drivers but do i install it as a usb to serial and set a port to connect to it using software?
please excuse my lack of knowledge on this device as ive never used it.
My sister and I have the same problem with ours, we wanted to use ours the other day but the laptop with all the drivers was sold and we forgot to send the drivers to the new laptop and now we dont know where to get any of the drivers.
Find the usb chip on the board. It would be near the USB plug and google for a driver.
My DLC board has a CH340 usb interface chip. CP2102 is in my ESP-WROOM.
If it’s Arduino based, that should be easy.
Good luck
