I have recently installed an x5 mini wifi board with a viki 2 in my prusa i3 clone. after a lot of setup configuration issues i finally got it to start printing. It has frozen mid print 3 times on 3 different print files so far. I am not able to get any information from the unit because it completely freezes and is not responsive to any commands. I am getting the red led on the board flashing but I cannot get any response from the viki or my computer. It has done this at random points on all 3 files. My drivers and stepper motors do not feel hot at all. it has frozen on layer 1 and on layer 15. any suggestions?
Imported from wikidot