You can see on the rightest square a edge not wanted. Print with skeinforge.
Any idea to remove it?
I checked stepper voltage and all is right. X stepper was 0.41V but now it’s .401V.
Z axis and Y axis are respectively 0.398 and 0.402v.
I checked also Y and X belts. Don’ t know where to look in settings to make thing better.
Originally shared by Bruno Pettorelli
Print is better but it still lefts some artefacts on the right of each square
Looks a little warm. Have you tried point a fan at it while it prints?
Axon2 instead of SF?
Abs?
Wow looks like u printed w/ butter
@John_Cooper_choffee , I setup 195°C for the print. I was printing the bracket for a fan in the same plate.
@Anthony_Truss , axon2 ?? It’s PLA.
Did the fan make a difference. I just tried hold the fan near mine yesterday and for small objects it makes a huge difference. You might want to try slightly lower temperatures. I think I am at 190 at the moment but have got good results with 185 as well just could not get it to stick to the bed.