Using some spice to mill some clamps for the shapeoko with  and ChiliPeppr  .

Using some spice to mill some clamps for the shapeoko with tinyg and @ChiliPeppr . As you can see my hex head washer setup is pretty amazing to be sure. However I thought it might be slightly better to mill some nice clamps. These are from the shapeoko product page and can be downloaded here:

I edited the dxf’s a bit to make is all able to be milled with a 1/4" end mill. (Home depot special!)

@Dat_Chu I sure could have used a nice tinyg pendant for my phone to be able to tell how far my job was :slight_smile:

Working on it …

Btw, what spindle do you have? Contemplating getting one but I am not sure if it is any good.

Here is a video of the spindle I have: