So the laptop that I was using for 3D printing,

3D Printing HercuLien and Eustathios
1

So the laptop that I was using for 3D printing, the solid state drive failed. I didn’t have any of my repetier host settings backed up. ugh…

I’m using an azteeg x5 mini. If I remember correctly, I need to install something to communicate with the x5 mini. Where would I get that file?

2

I’m using pronterface ( http://www.pronterface.com ) to connect to my Azteeg. Works well thus far… but I’m still at the setup/ initial runs stage.