Hi, I’m really happy about the V2 boards finally being anounced! Good job guys.
Are you planning to add proper IDEX support in the V2 firmware, meaning dual extrusion, simultaneous printing and mirrored printing? I read that currently there sort of is a way to get it working using the switch module but it is aparently a bit of a hacky solution.
Also, I guess it will be possible to add a (limited) number of external stepper motor drivers to the GPIO pins and map them to any axis as needed (without necessarily using the dual extrusion extension board)?
Maybe you can tell from the questions, I am thinking about building an IDEX printer based on the V2 prime.