Since i now have the Rumba board with potentially three extruders i can connect,

Since i now have the Rumba board with potentially three extruders i can connect, i needed a few more heaters :slight_smile:

https://lh4.googleusercontent.com/-63oyp5Tq930/UST- B1a95LI/AAAAAAAAAlY/FznB8pe3VxQ/s1198/P1020909.JPG
https://lh4.googleusercontent.com/-63oyp5Tq930/UST-B1a95LI/AAAAAAAAAlY/FznB8pe3VxQ/s1198/P1020909.JPG

Have you been able to get your endstops working with your Rumba. If so, which two pins are the signal and ground pins? Thanks.Can’t get mine to work.

Are these hot ends?

@Roy_Griffith I had no problem with the Rumba, the pins are clearly marked. The outer pins are +, the middle - and the ones towards the inside of the pcb are signal.
@Tony_Hine_Nifty_Acce Only the heaters, you can see more on the complete hotend here: http://hackerspace-ffm.de/wiki/index.php?title=Benutzer:Srek

Thank you @Bjorn_Marl