Reversed Coordinates

Hello,
I am brand new to the world of CNC, and can’t wait to get started. After making many stupid mistakes while setting up my machine, I have one last issue. While the machine is finally taking commands, the coordinates are completely reversed. What should be a + is a -…… you get the idea. I obviously cannot cut anything because of this issue. Any suggestions out there among my new community? Thank you very much.

Sincerely,
C+C No Music Factory

Tell us more about what machine you are using. Is this a kit you built?

Depending on the machine, this might be easy to change in software; it’s also possible to change in hardware.