Regarding the QU-BD One-Up and Two-Up printers:

Regarding the QU-BD One-Up and Two-Up printers:

I haven’t seen a good picture of either model’s electronics in final wired form. Has anyone published a picture showing the backside of the printer and how the wires (cables) and electronics are all nice and neat? Or is there such hope? Most of the pics I’ve seen are either all zoomed in or of just the board or just the printer or a few sections of the printer. Many photographers go out of the way to actually hide all of the electronics altogether. There might be some out there and I have just over looked them. Any specific suggestions?

I’ve made some progress in my build, but I fear I may not be as precise, as accurate, or as much of a perfectionist as I may need to be. I’ll post some of my own pics tomorrow. I didn’t resolve the belt issue. I’m not sure I want to cut that otherwise perfectly good belt. I’m wondering how long it will be before I get the correct one.