PT100/Thermocouple support? So far the only mention i've found is a par of lines

3D Printing
,
1

PT100/Thermocouple support?

So far the only mention i’ve found is a par of lines in the documentation for the e3d amplifier “thermistor” table, and another generic 0.005V/cº

But, how do you connect this to these to the replicape? Certanily not as a thermistor, and if i’m not mistaken, beaglebone ADC inputs only support up to 1.8v, so also its a no-go.

Any ideas?

2

There was a discussion I didn’t really follow in the slack, about installing a voltage divider to not fry the BBB underneath. Take a look at the Replicape slack archives maybe?