Probably allready suggested, but what about a timer that shows estimated time and percentage?

Probably allready suggested, but what about a timer that shows estimated time and percentage?
Also maby like LaserGRBL live view of the laser in the workspace?

Thanks for this usefull software and for the, I’m sure, HUGE amount of work put down :slight_smile:

It already shows the live location on the grid…

@CescoAiel Really?.. does not here :confused:
But would have been great to have elapsed and remaining time also :slight_smile:

It should show a light blue circle (or cone if you’ve tilted the view) for the laser!

Jepp, the blue dot is there, but not moving :slight_smile:
I have the following ticked:

Show gcode
Show laser
Show documents

I agree on the timer/percentage, but that apparently isn’t that simple, and you have to stay with the machine anyway while it’s working, so it’s not a biggie to me…

@CescoAiel You have no idea as to why the laser blue dot is not moving? :slight_smile:
BTW, thanks for taking the time :slight_smile:

I was boarding my flight, hence the delay…

I have no clue, perhaps the board is not providing whatever feedback LW is expecting? You’ll have to wait for the devs to answer that one…

@ATN11 Did you setup $10=0 as it should be?

Hmm… Not sure, will check later :blush: thanks