Probably a dumb question, but how is the door stop supposed to work on the Herculien?
Don’t use my lid stop. Not strong enough. But the door stops get magnets glued in:
@Eclsnowman Thanks, that makes sense with the magnets. Think the lid stop would be strong enough in the carbon filled PETg? I have about 500 grams, but I’m waiting to run it through my Volcano until I can get a hardened nozzle in a size smaller than 0.8mm
@Zane_Baird I think if it was straight, not a curve it would work well. The curve unloads when in tension.
@Eclsnowman I see… Up to this point I’m running it without a lid so it’s not a big deal, but I’ll have to draw something up when I install the lid. However, my first priority is finding time to finish my design of a dual carriage that fits an E3D v6 and Volcano on the same setup. One for small prints, one for large drafts.