polycarbonate•PC d038|17 just fantastic, prints well, looks good and is super strong.

3D Printing
,
1

polycarbonate•PC d038|17

just fantastic, prints well, looks good and is super strong.

temp at 232°C with 25% inceased flow (viscosity compensation)

The probe cuvette is two walled at bottom with air-gap — merging into singlewalled at top.

9442bf8e32e5febe8c9d4f8367be6ba6.jpeg
9442bf8e32e5febe8c9d4f8367be6ba6.jpeg1417×1772 471 KB

d8f7c5ff27cea89ca44f047e573f0377.jpeg
d8f7c5ff27cea89ca44f047e573f0377.jpeg1535×1920 472 KB

d4b946546855f9b1a2f91fd0a284dca3.jpeg
d4b946546855f9b1a2f91fd0a284dca3.jpeg1536×1920 309 KB

8022cafa7698c29169952db2d584e72f.jpeg
8022cafa7698c29169952db2d584e72f.jpeg1750×1920 468 KB

4f134ae84872ee479ba132b42f5b4f9e.jpeg
4f134ae84872ee479ba132b42f5b4f9e.jpeg1427×1142 256 KB

4515d21671c37d8b8d0c71bf28612dbf.jpeg
4515d21671c37d8b8d0c71bf28612dbf.jpeg1798×599 180 KB

e8c3d88cc5178f28b3d8e7e47c410ae7.jpeg
e8c3d88cc5178f28b3d8e7e47c410ae7.jpeg1920×1536 380 KB

2

Wow surprised it prints at such a low temp. How’s the layer adhesion?

3

It is like one piece … (without the increased flow it become less translucent and with a bad layer adhesion)

4

@Ulrich_Baer ​ why you made it double walled ?

5

It is a »probe« to see at which distance two walls fuse together.