Originally shared by Rob Giseburt
Yoda, printed at a layer height of 0.15mm.
Other stats:
“Natural” color ABS (MakerBot)
50mm/s perimeters, 80mm/s infill, 150mm/s travel
Replicator 1, custom firmware, no hardware mods.
Originally shared by Rob Giseburt
Yoda, printed at a layer height of 0.15mm.
Other stats:
“Natural” color ABS (MakerBot)
50mm/s perimeters, 80mm/s infill, 150mm/s travel
Replicator 1, custom firmware, no hardware mods.
I should note that this is uncleaned, still stuck to the platform. I shot the photos in ways that would highlight the glitches.
wow
Cool
Hmmm, nice it is!
@Nils_Hitze Sure! All of my photos on G+ are Creative Commons BY-SA (http://creativecommons.org/licenses/by-sa/3.0/). I’m curious about the topic, though.