Originally shared by René Jurack Why would you drill a hole into a 70€-extruder?

3D Printing
,
1

Originally shared by René Jurack

Why would you drill a hole into a 70€-extruder? Because it is a perfect mount for zipties!

4cba9a90d80f3ebcb9d2505d8692b348.jpeg
4cba9a90d80f3ebcb9d2505d8692b348.jpeg4032×3024 2.41 MB

d258dd1efc533069d589f79c690579a8.jpeg
d258dd1efc533069d589f79c690579a8.jpeg3024×4032 2.19 MB

2

Did @E3D_Support see this yet? :slight_smile:

3

Clever

4

What kind of connector/wire harness is that? Super clean looking.

5

it is an 8-pin MPX-plug