Originally shared by cato hagen
Tried printing the cigarette holder http://www.thingiverse.com/thing:52272 in Taulman nylon, but getting weak layers, i can peel layers off with no effort using one finger…used 240C and feed 35…faulty nylon batch ? anyone else getting this weak prints ?
Two things I can think to try: Lowering your layer height, and increasing temperatures (this includes making sure the area around the nylon stays warm). Unlikely a “bad batch” - keep in mind Nylon is an experimental material.
Perhaps your flowrate is not high enough? Layer adhesion comes from enough heat and enough “smoosh”.
