My biggest/longest Print so far
12 hours, around 195 g of white PLA, printed with an #ultimaker , 0.2 mm, 220 degrees, 10% infill
Very nice details - but still some minor errors i’d like to fix over time.
Originally shared by Nils Hitze
Ph’nglui mglw’nafh Cthulhu R’lyeh wgah’nagl fhtagn
Yes - but that won’t work with PLA afaik
It won’t work with PLA @Nils_Hitze , don’t try it
@Nils_Hitze I looked back through your posts to answer this question, with no luck… Is that blue painters tape on your bed?
Or something special?
Great job! What PLA are you using?
Jason_Hsu
(Jason Hsu)
8
Nice. What thickness and infill?
Jason, see post 0.2 mm & 10%
@Chris_Vestal blue painter tape from 3m
That’s a super cute figure! Are you gonna paint it or do any finishing to it?
Three thumbs up !! =)
Will be sanded a bit, then primed and painted.
Please do share shots of the final figure!
Nils_Hitze
(Nils Hitze)
14
17 cm high, i’ll post a photo with a ruler next to it later