MKS DLC32 cannot handle higher speeds

Controllers
1

Just installed an MKS DLC32 on a 130W CO2 laser.
On the left, I have 20% power and a speed of 20 mm/sec.
On the right, I have 20% power and a speed of 100 mm/sec.

I don’t understand why the laser doesn’t burn all the lines when running at a higher speed.
When I run the same job on my K40, the result is perfect at the higher speed.

Laser
Laser2267×2267 754 KB

2

The problem is solved. I changed from using active high to active low, and now everything works.

2 Likes