Mill Cut Outside with tabs

[enhydra (Kurt Meister)]

By now I did not care about the fact, that after each cycle the z axis retracks back to +1 before it dives in for the next pass. But since the MaslowCNC is very slow in thr z axis I do care.

Is there a workaround for this? Btw I’ve got no retraction without tabs…

[cprezzi (Claudio Prezzi)]

You could try to split the job in two operations. First only the pathes without tabs and then one operation for the last path with tabs.

[enhydra (Kurt Meister)]

Sounds good. I’ll try that