Made this small angel decor art for my door It took about 2 hours

ox
gplus
(Mike Gallo) #1

Made this small angel decor art for my door
It took about 2 hours ,prep and finished.
Use a 0.25 end mill for rougher (60feed_ 30speed) and a 2mm ball nose bit to finish (40feed_40speed) , I use a 1/8 end mill bit to cut out the decor.
Material Mdf - rpm set to 17700, DeWalt

(Jack Daugherty) #2

Looks pretty good! Nice job.

(Mike Gallo) #3

I try it to carve some old wood and I end up braken apart, after 30 min routing, darn a made it too thin 1/2 inch
08d1e6a9d9da193736936888c4a87ef0.jpeg

(Colin Kaminski) #4

It really takes me a lot of concentration to align all of those bits. Nice work.

(Mike Gallo) #5

:grin::yum:

(Mike Gallo) #6

It’s a 6 feet tall wall decor, https://plus.google.com/photos/108921378497443668729/albums/6659473180195420145/6659473176813521650