.Machine type: K40 .. Controller type: M2Nano 6C6879-LASER-M2:9 .. Firmware: .. Firmware config:

Lasers
,
1

#K40brokeXAxis

.Machine type: K40
… Controller type: M2Nano 6C6879-LASER-M2:9
… Firmware:
… Firmware config:
… Problem tenacity: new problem

Help!

Hello! After engraving , I am having this problem: The stepper motor of the X axis, is failing, can be seen on the http://video.It sounds weird while moving and jump.

I have test the X motor on the conection of the Y Axis and it works OK. Limit Switch works OK.

Could be a controller problem, Should I remplaced it?

Thanks in anticipation!

c4b3bf98ffeffdabb6577bcb37713164.jpeg
c4b3bf98ffeffdabb6577bcb37713164.jpeg1920×1080 198 KB

2

Can you swap x moter conection wit the y on on the controler board and see if fault follows

3

@Phillip_Conroy yes! I did
, and the fault continues

4

I have had similar problems and it has been a bad wire or connection. Maybe disconnect motor and check with ohm meter and wiggle all the wires.

5

@Martin_Dillon I did and woks ok in the Y axis. Motor Y on X axis same problem.

6

@Yosman_Canizalez Did you solve your problem? I think I’m in the same problem as yours.

https://plus.google.com/111567065741989535353/posts/a16wy1K32GP

7

@Fabiano_Ramos Hello! Yes, I did, I changed the mainboard and it solved the problem. The seller sent me a new mainboard.