LaserWeb4 Basics. I hope this video helps new users and shows the basic LW workflow.
#LW4basics
OK I’m going to have to watch this video a few times but I think I can get it. I finally got LaserWeb to write a Gcode. Now in Ventric V Carve the Gcode is written in about 5 seconds. It takes over 15 minutes to write Gcode from LaserWeb. If LaserWeb is this slow is there a post processor for LW4 I can use in Vcarve? Thank you for your patients.
@bbowley2 wow 15min? We need to see that type of file. I have never seen that before. Please share it or something similar for us to review
It.s coming along a little. I’ve generated a Gcode and I can now jog but only on the Y access. How do I activate the X access? My machine ID is “gen_smoothie” is this correct?
I don’t know what reasons would there be for an axis not to move. When did it stop moving