Just checking out some faster settings...turned out pretty good as far as I'm concerned.

gplus
(Scott Thorne) #1

Just checking out some faster settings…turned out pretty good as far as I’m concerned.

(DIY3DTECH.com) #2

Dude! Blade Runner right? Very nice, I like this one the best!

(Scott Thorne) #3

Yup

(Gary McKinnon) #4

My favourite film of all time ! :slight_smile: What speed were you at with this one, looks great ?

(Scott Thorne) #5

400mm/s

(Gary McKinnon) #6

Fast! I thought the limit on these was 350, but i read somewhere else it’s 500.

(Scott Thorne) #7

Mine is 500mm/s…my power stays around 6 when I’m engraving and 8 when I’m cutting.

(Andrew ONeal (Andy-drew)) #8

Is all work done in Corel or inkskape, I posted my first ever post above with my issues. Best guess design in inkskape then send to laser via pronterface? Will Corel work the same way or Corel files have to be ran through inkskape to generate gcode?

(Scott Thorne) #9

I’ve never use inkscape…I use Corel laser or laser draw.

(Andrew ONeal (Andy-drew)) #10

Wait, you still use moshidraw electronics?

(Gary McKinnon) #11

Good results, what speeds ?

(Scott Thorne) #12

No…I have m2 nano board…I use coral laser.

(Scott Thorne) #13

4mA at 400mm/s

(Gary McKinnon) #14

Fast !

(Scott Thorne) #15

@Gary_McKinnon …thanks…I think I’ve got it setup like I want it now…now more up grades for the moment.