Just a thought ,

Just a thought , would it be possible to wire 2 stepper driver boards in parallel to drive a higher amp stepper??
for example these …Dual H Bridge DC Stepper Motor Driver Controller Board ModuleL298N Arduinos these are just £2 each and run 2 amps
so maybe 2 would run at 4 amps ??
Thanks for any input,stevep

Those drivers are fucking terrible, don’t even think about using them imho.

Just get the right steppers, and the right drivers. It’s worth the money so that you don’t murder anyone.

Thanks for your replys to you all…maybe there is a kit of components and circuit board that will drive a nema 34 ,any one know of ??? …dont mind a bit of soldering to save some money
Thanks …stevep