Intresting thing happening here. Not connected to smoothie but I can do outlines.

Intresting thing happening here. Not connected to smoothie but I can do outlines. :open_mouth:
Perhaps someone else can figure out what’s going on?

Yes i updated a setting and it refreshed, just tried to do it after a reboot,
Does not do it unless it has been connected once before but after a refresh it will outline when not connected.

in a way it would be nice to refresh the program without needing to reconnect.
currently refreshing is the only way to remove loaded G code?

I will check the serial communication again. It’s possible that a lost and reconnected websocket creates a undefined state.

Done. Pull the new version which restores port status on page reload :slight_smile: