Inspired by http://3dprintingindustry.com/2013/02/08/reprap-forums-3d-print-something-tiny-challenge/ , I wanted to see how small my Huxley can go.

Andreas_Gohr · February 9, 2013, 8:48pm

Inspired by http://3dprintingindustry.com/2013/02/08/reprap-forums-3d-print-something-tiny-challenge/, I wanted to see how small my Huxley can go. This is http://www.thingiverse.com/thing:8896 downscaled in Slic3r to 20% using a 0.2mm layer height. Sitting on a e Euro-Cent coin (1.9cm across).

foosel · February 9, 2013, 8:54pm

Awwww, sooo tiny!

Stephen_Baird · February 9, 2013, 9:00pm

Itty bitty!

Thomas_T_Sorensen · February 9, 2013, 9:02pm

Layer height?

Nils_Hitze · February 9, 2013, 9:11pm

0.2 mm

Nils_Hitze · February 9, 2013, 9:50pm

#tinycontest

Nils_Hitze · February 9, 2013, 9:55pm

What Nozzle Size do you use?

Andreas_Gohr · February 10, 2013, 11:59am

I’m not 100% sure but I think it’s a 0.35 one