If you’re following the instructions in my Kossel BOM, please provide feedback.
On the subject of the BOM - this is a design in flux, and have some have seen, the Kossel is still mid-design; the design will fundamentally change to reduce the number of printed parts into “unified corners”, where the four parts that go into each lower corner will become a single, unified print.
That will add stability, and simplify the BOM/instructions (and increase the difficulty of getting a good quality printed part out of that corner) - but for a million reasons, including the fact that the first printer I’m building is actually for the office, not for home… so this BOM will, at least for the forseeable future, focus on the completable now, rather than the incomplete future.
https://github.com/ctoforaday/kossel/blob/bill_of_materials/BOM.md