I would like to know if someone here would being willing to help me with a project? My son was sworn in as a Deputy sheriff in the area that we live in today, he asked me if I would make him a badge holder! At first I was hesitant to wan to do it because of my lacking ability with Ink scape or the other types of programs so far. what I would like to create for a badge holder would take 2 pieces of leather one piece would have the 7 points like the badge and it would have a round ring, the outer piece would just be the round backing piece that I would glue and sew the inner leather that would be shaped like the badge on the inner part and round. I hope this makes sense and not sure if I could find a sample that is made over seas. I will look to see if I can find one and then post the sample.
Thanks
well I take it back after doing another restart it let me delete the program from the computer but tomorrow is another day and I will get at then this beat me up today shesh
Any luck today?
no in fact it has become even worse, I did find an extension after looking back at the stock software for extensions that it would open and found that I could save the file with that extension and saved it as such. Now for the bad part, I went back and followed all the steps to remove the driver for whisperer and reloaded the stock software after having to do a dance around the machine and hold my breath and crossed my fingers, but to no avail, not only will it now not engrave with the stock software I am not certain after following all the steps to remove the usb driver for whispere. so I must say that the warnings need to be taken for real it got to the point where I had to give up again today after the frustrations that this has caused, and to think I just wanted to do something nice for my son, now I am stuck!!! I will get back at it tomorrow after a DR’s appointment and dealing with the V A after they screwed me over so I hope I can come out of this with little scaring and a machine that will work!!!