I see the following in the redeem log file:

3D Printing
,
1

I see the following in the redeem log file:

2016-02-18 04:19:14,660 root ERROR Alarm: Stepper Z

I was actually printing and there was some issues with the extrusion and I stopped the print. After I stopped, I saw the above message in the Octoprint terminal and in the redeem log file.

The printer continues to move and heat up, etc. I haven;t tried printing again.
What’s going on?

2

That is most likely too high current on Z. Try lowering it.

3

Thanks Elias, I’ll try that. I have two Z motors connected and driven together, so I made the current higher (1.2 amps). Maybe I will disconnect one and try cloning it on the H driver.

4

Lowering the current fixed the alarm. Thanks Elias!